Feature

●Needle point with flat retainer built into a flat sheet retainer
●By inserting this bearing between the relative two planes, you can perform a smooth back-and-forth movement with a small coefficient of friction
●The FF shape flat roller is made of polyamide resin in its retainer
●Both ends of the retainer have a groove type of coupling groove, allowing you to use any combination of the retainer units
●FF. ZW shape has a double row of needle points and an elastic seam in the middle of the retainer


Description

Features:
The flat plate retainer has a needle point built into a flat plate retainer, and it is designed to be used between two parallel planes.
By inserting this bearing, you can perform a small back-and-forth movement with a smooth coefficient of friction.
The FF shape flat roller uses polyamide resin for its retainer, and the ends of the retainer has a groove type coupling groove, so you can connect several units of the retainer to any other.
The FF. ZW shape has a double row of needle points and an elastic seam in the middle of the retainer.
After heating the flat roller in oil from 70 to 90 degrees Celsius and bend it to any angle, you can hold it at any angle
Even if it cools for a few seconds, it can maintain its shape even when it returns to room temperature. It can be attached to the V-surface.
The BF shape flat roller retainer is made of steel plate press and the length of the unit is standard 39.4 inches (1,000 mm).
The RF shape flat roller is a polyamide resin retainer and the length of the unit is 27.8 inches (705 mm).