Feature

●SinLoon 3.5 Sata-IDE 40 Pin PCB Adapter: 1 Female SATA 7 + 15 Pin Port, 1 3.5 Male PATA Port (40 Pin IDE) and 1 4 Pin Molex Converter Adapter
●Connect SATA devices to IDE / ATA motherboard or controller card
●Connect CD-ROM / CD-RW / DVD / DVD-RAM / HDD devices with SATA connector to motherboard with IDE connector
●Supports 2.5, 3.5, and 5.25" SATA HDD
●With a 4-pin power adapter, the SATA-IDE adapter provides power to itself and SATA hard drives simultaneously, so there is no need to connect a hard disk to the power source of SATA hard disk. No driver needed. Plug and Play


Description

SinLoon 3.5 Sata-IDE 40 Pin PCB Adapter
1.SATA 7+15 PIN Female
2. IDE 40 PIN Male
3. D Type 4 Pin Power Adapter
Compliant with SATA rev. 1.0 standards
Ultra ATA 133 Standard
Complete hardware solution No software required
Convert adapter for IDE to SATA HDD / Optical Drive that can connect SATA 1.0 / 2.0 / 3.0 drive to motherboard IDE / ATA 33/66/100/133 port
Cost-effective solution for using new SATA drives without replacing your existing motherboard.
This IDE / SATA adapter is the solution to fill the gap between the new 2.5 / 3.5 / 5.25 inch SATA drive and the old IDE motherboard port. It also supports optical disk drives, so you can add Blu-Ray, DVD or CD-ROM drives to your legacy IDE motherboard.

◆Plug and Play: Free drive
◆Transmission speed is 1.5GB/S.
◆Standard ATAPI, ATA / 133, ATA / 100, ATA / 66, ATA / 33. EIDE support standard IDE (3.5) storage devices (hard disk, DVD, DVD-RAM, CD-ROM, CD-RW ...
Installation Instructions:
1, Support IDE motherboard with SATA hard drive
1, Always turn off the computer before operation.
2, Open the computer case, insert the IDE card holder of the riser card into the IDE socket of the computer motherboard (IDE interface motherboard).
3, Connect one end of the SATA data cable to the SATA card of the riser card, one end of the SATA device to the SATA port, and follow the following diagram to set the switch and jumper.
4. Connect the large end of the power cord to the power cord of the chassis power supply. The smaller end connects to the power socket pin of the riser card (white sheet, 4 pins, cannot reverse the direction). Plug in the power cable of SATA devices at the same time.
5, When the computer is connected, the computer will start BIOS for device detection, and the host computer correctly identifies and power the connected SATA devices.
Next, the adapter card in this set is a one-way adapter card that is used for SATA hard disk or optical drive used in IDE motherboard. 7+ 15P SATA port can be directly connected to a 2.5" SATA hard disk or 3.5" SATA On hard disk or optical drives, this card features that the card connects directly to the device and does not require a SATA cable for transferring.