Feature

●This analyzer SWR range is 1.09.99. Step sizes are user configurable increments of 100Hz, 1KHz, 10KHz, and 100KHz
●2.1mm power jack center pin uses DC 12 to 14V 500mA external power source with positive power and plug in the power supply to work
●The 5 operation buttons are easy and convenient to operate. You can choose between operating modes, bands, and extensions
●Beautiful and simple design black case protects your antenna analyzer from external damage
●This makes a great SWR antenna analyzer for ham enthusiasts and professionals


Description

Specifications:

Frequency Generation and Control: 1-60 Mhz

Source Impedance: 50 Ohm

Stability: +/- 100 ppm

Spectrum Purity: Harmonic Down> TBDdB above -60MHz

Step Size: 100 Hz, 1 kHz, 10 kHz and 100 kHz user programmable increments

SWR usable measurement range: 1.0 - 9.99

Impedance: Approx. 5-2000 Ohm

RF Output: Adjustable 2.0 volt pp (type)

Power Supply: External 12 - 14 V DC, Powered from 500 mA

Push button (5): "Mode", "Band", "Configure", "Scann", "Up", "Down"

Switch: "Power On"

Connector: RF

USB: Mini-B receptacle

External Power: 2.1mm power jack (center pin is positive)

Battery operated: 8 AA batteries (sold separately).

Size: 5.9 x 3.54 x 1.57 inches (150 x 90 x 40 mm).

Application:

1. Measure the electrical parameters of the antenna: SWR, impedance (resistor + reactance), capacitance, inductance

2. Measure the power supply point impedance

3. Measure ground loss

4. Adjust the antenna tuner to determine the loss

5. Measure inductors and capacitors

6. Measure coaxial transmission line (SWR, length, speed coefficient, approximate Q and loss, resonance frequency, and impedance)

7. Measure and decide optimal settings for tuning stub: SWR, Estimated Q, Resonance frequency, bandwidth, impedance

8. Determine the transmission track characteristic impedance

9. Loss of coaxial cable

10.Determine the loss of antenna tuner

11. Measure balance loss

12. Measure the inductor Q

13. Estimate the parameters of the crystal oscillator

14. Measure magnetic loop resonance and SWR

Operation Button Function:

Mode: Choose between working mode, impedance (default), complex impedance, capacitance, and inductance

Band: Select the band from 160M to 6M available band

CONFIG: Provide configuration and extension, PC links, step size, suspension timeout settings, calibration, and software upgrades menu.

Scanning: Press this control to start scanning the frequency of the selected band. The scan exits impedance mode and indicates the bandwidth of the 2:1 and the antennas resonance point

CAN (up): Use to increase frequency and cancel operation in CONFIG menu

VAL(down): Used to reduce frequency and validate the operation of the CONFIG menu

Package Includes:

1 x Analyzer (Power supply not included)