The HTIII 100mm holder is robust and precise and comfortable to operate.
Up to 3 filters at the same time when shipped.By replacing the included short screws, you can decrease the filter slot to two frames for even greater vignetting power.
Includes HT100-82 adapter ring and 3 step up rings as accessories, compatible with filter diameter 67/72/77/82mm.
With a variety of HT100 adapter rings for 3.7 - 2.6 inches (95 - 67 mm) sold separately, it can be used with a wide range of lenses from 3.7 - 2.0 inches (95 - 52 mm).It can also be attached directly to the Nikkor Z 14-24mmf/2.8 and Sony 14mmF1.8GM with the compatible adapter ring sold separately.
|
|
|
---|---|---|
Premium CPL HT100-82CPL filter for KANI 100mm filter holder (HT3/HT2 common).Integrated with holder adapter, lens side filter diameter is 82mm. The effect of the CPL can be adjusted by rotating the gear on the outer frame of the holder. Also included in most KANI 100mm filter sets. |
Premium Frame CPL 100mmCPL filter for KANI 100mm filter holder (HT3/HT2 common).The entire metal frame is set to a fixed frame just like a square filter, making it easy to put on and take off the CPL while shooting.The effect can be adjusted by turning the turning knob on the frame. Super wide angle lenses are prone to vignetting and are typically installed on the front side (near the lens) filter slot. |
Premium CPL 100X100mmAll round CPL filter for KANI 100mm filter holder (HT3/HT2 common).The effect can be adjusted by rotating the holder itself.Therefore, it is not suitable for use with various half ND filters. Also suitable for use with HT100-86mm/HT100-95mm adapter rings that do not use CPL adapter rings. |
|
|
|
|
---|---|---|---|
1. Choose the adapter that matches the lens filter diameterThe included HT100-82 adapter ring allows you to attach the adapter ring directly to the lens with a filter diameter of 82mm. For lenses with filter diameters of 67mm/72mm/77mm, the included step-up ring is attached to the adapter ring. |
2. Attach adapter ring to lensAttach the ring you choose from 1. on your lens to the filter screw on the end of the lens. If your lens protection filter is installed, please take it off basically before attaching it. Wide angle lenses may cause vignetting and increase in filter quantities may cause image quality. |
3. Attach the outer frame of the holder (filter mount)When the outer edge of the HT100-82 adapter ring is hooked onto the nail on the outer edge of the holder, the adapter ring is pushed into while adding a nice knob on the holder outer frame. Spring integrates the adapter ring and the outer rim.The outer frame can be rotated freely after fixing. |
4. Install the square filterInsert the square filter into the slot of the holder.Insert the filter into the same slot on the left and right so that the filter side is parallel to the lens surface. Shipment can be used up to 3 pieces at the same time, but basically use them from the slot on the front side (lens side). Because the urethane used for light shielding is attached to the outer frame of the holder, it will be harder than other slots. |
HT100 III Holder + CPL | HT100 III Holder | HT100 III Holder Outer Frame Only | H100 Hand Holder | Single HT100 III Switch Holder | HT100 III Switch Holder + CPL | |
---|---|---|---|---|---|---|
Filter holder outer frame | ○ | ○ | ○ | - | - | ○ |
Single switch holder | - | - | - | - | ○ | (already installed on HTIII filter holder outer frame). |
Adapter Ring HT100-82 | ○ | ○ | - | - | - | ○ |
Holder adapter integrated CPL | ○ | - | - | - | - | ○ |
Step-Up Ring for 67, 72, 77mm | ○ | ○ | - | - | - | ○ |
H100 Hand Holder | - | - | - | ○ | - | - |
Holder + CPL | Challenge Set | Starter Set | Handy Set | Standard Set | Premium Set | |
---|---|---|---|---|---|---|
HT III 100mm Holder + CPL | ○ | ○ | ○ | - | ○ | ○ |
H100 Hand Holder | - | - | - | ○ | - | - |
P. Hard GND 0.9 | - | - | - | - | ○ | ○ |
P. Soft GND 0.9 | - | ○ | - | ○ | ○ | ○ |
P. Reverse GND 0.9 | - | - | - | - | ○ | ○ |
ND16 | - | - | - | - | - | ○ |
ND64 | - | - | - | - | ○ | ○ |
ND1000 | - | - | ○ | - | ○ | ○ |
P. Dual Purpose GND 0.75 | - | - | ○ | - | - | - |
P. Dual Purpose GND 0.9 | - | - | - | - | - | - |