1. Remove the lens side adapter from the outer frame of the holder (filter mount)

By pulling the knob on the outer frame of the holder and removing it from the fingernail on the outer frame of the holder, the lens side adapter can be removed.

2. Attach the lens side adapter to the lens

Loosen the retaining screw on the lens side adapter and insert it into the recessed position of the lens tip from the front of the lens to match the position of the fingernail inside the lens side adapter.Tighten the fixing screw firmly where the lens mirror body and the nail on the side of the adapter touched.

3. Attach the outer frame of the holder to the lens side adapter.

When the outer edge of the lens side adapter attached to the lens is hooked onto the nail on the outside of the holder, tuck the knob in the holder outer frame into the adapter ring.

Spring integrates the lens end adapter and the outer rim.The outer frame can be rotated freely after fixing.

4. Install the square filter

Insert the 150mm wide square filter into the slot of the outer frame of the holder.Insert the filter into the same slot on the left and right so that the filter side is parallel to the lens surface.

When shipping, you can use up to 2 sheets at the same time, but basically use them from the slot on the front side (lens side).

Because the urethane used for light shielding is attached to the outer frame of the holder, it will be harder than other slots.

1. Choose the adapter that matches the lens filter diameter

The HT150-95 adapter ring included in the set can be directly attached to the lens with a 95mm filter diameter.For lenses with 72mm/77mm/82mm filter diameters, please select the included 95mm step-up ring and use it with the included lens.

For lenses with a 4.5 inch (112 mm) filter diameter, the HT150-112 adapter sold separately, and the lens with a 4.1 inch (105 mm) filter diameter can be attached directly to the lens.

For lenses with filter diameters of 2.4 / 2.6 / 3.4 inches (62 / 67 / 86 mm), please use the HT150 - 95 adapter with 3.7 inches (95 mm) step-up ring (sold separately).

2. Attach adapter ring to lens

Attach your lens adapter ring to the filter screw on the end of the lens

If your lens protection filter is installed, please take it off basically before attaching it.

Wide angle lenses may cause vignetting and increase in filter quantities may cause image quality.

3. Attach the outer frame of the holder (filter mount)

When the outer edge of the attached adapter ring is hooked onto the nail on the outer frame of the holder, the adapter ring is pushed into while adding a nice knob on the holder outer frame.

Spring integrates the adapter ring and the outer rim.The outer frame can be rotated freely after fixing.

4. Install the square filter

Insert the square filter into the slot of the holder.Insert the filter into the same slot on the left and right so that the filter side is parallel to the lens surface.

When shipping, you can use up to 2 sheets at the same time, but basically use them from the slot on the front side (lens side).

Because the urethane used for light shielding is attached to the outer frame of the holder, it will be harder than other slots.